So I finally had some cooperative weather today and was able to get some dry wood so I could take a stab at making some char cloth from some cut up old jeans. I started by splitting some wood with my ESEE 5 and then used my Mora Companion to shave and also do a hasty and ugly feathering of one piece to get some kindling since everything is still sopping wet that I could use around the yard.

While this isn't the best attempt at kindling for getting a fire started, I'm not trying to practice starting fires so I cheated with a little Vaseline and cotton to catch my spark.

Alright so we have everything ready to get the fire going, Let's go ahead and move the Lixada stove over to a better place and get some fire going!

I forgot to take photos of cutting the pant leg of an old pair of jeans up and placing it in the can but with a little imagination I think you can get the idea of taking scissors, and cutting jeans ha! While a lot of people prefer to use Altoid tins all I had handy was this can that a brush for my beard came in, since it does seal very well (I actually had a hell of a time getting it open after making the char cloth) I went ahead and punched a hole in the lid with a screw.

The can I was using was rather big and I put quite a bit of denim into it. This was my first time making char cloth and I did go a bit overboard, I had to feed wood into the Lixada for more than 45 minutes until smoke stopped coming out of the char cloth can. Next time I'll use a smaller can and do less material at once.

As I said above I just used too large of a can and put too much material in, several pieces were still far from being done, especially where seams were stitched together down the side of the pant leg. Learned a few lessons and will apply them to my next attempt. I grabbed one of the pieces that felt the driest/most charred and put it in a little stainless steel sauce cup, the FIRST spark off of my ferrocerium rod got the char cloth going, VICTORY IS MINE! I'd ask you to forgive the poor photo as it's hard to hold a phone, shield the screen from direct sunlight, blow on the char cloth to keep it bright enough for the image sensor to see in the bright light, keep your long beard out of the way of everything and take the photo haha. As you can see, part of this piece still had denim that was far from being ready attached to it.